If you’re having a full kitchen renovation, set up the cabinetry and counter tops earlier than placing up the Pole-Wrap. This product is available in just a few sizes, so it’s essential measure the area you propose to make use of it in. Purchase the Pole-Wrap sheet sizes closest to the size of your backsplash space — whereas it is simple to chop, you continue to need to restrict ragged edges wherever doable. Lay the Pole-Wrap sheets flat on the ground or a big desk. Mark your top and width measurements on the sheets with a tape measure and pencil. Use a fine-toothed hand-held or round noticed to chop throughout the wood slats. Width measurements are simpler to chop down — use a utility knife to chop by means of the groove between the strips.
Now it is time to connect your cut-to-size Pole-Wrap sheets to the wall. First, wipe down all of the backsplash surfaces with a humid material and permit them to dry. Utilizing wooden glue and a caulking gun, squeeze traces of adhesive onto the wall about 10 inches aside. Use masking tape to safe the wrap to the partitions or counters (high, backside, and ends) till it dries. Most wooden glues remedy in 24 hours however test the producer’s directions.